Forum

Notifications
Clear all

6 yd Bell Target  

 
safeshooter
(@safeshooter)
Trusted Member Moderator

No awards for my carpentry skills, but I did make a fully functioning 6 yd regulation Bell Target for the target Air Rifle 🙂

The plate at the front was the only expense, everything else was lying around the garage.
The plate is regulation size in terms of bull (3/8 inch or 9.52mm)and I have a spare (as I could only order a pack of 2) which will be in the sales section later for any budding marksmen out there.....You dont need a target rifle for this, any air rifle or air pistol would do.

Zeroing at 6yds, two of these now zeroed were bell ringers.
The plate comes as unpainted steel with scoring rings

Will get another picture up later with the internal view of the bell and ringer

"it's a Fuster Cluck!"

Quote
Posted : April 10, 2020 12:11 pm
Barney liked
SeaMonkey
(@seamonkey)
Eminent Member Registered Registered

Do you have L and R written on your wellies as well? Just asking ?

ReplyQuote
Posted : April 10, 2020 6:37 pm
safeshooter
(@safeshooter)
Trusted Member Moderator

@seamonkey  😆 

My woodworking skills are so precise that it all had to go back n order (or it wouldnt fit together) 🙂

"it's a Fuster Cluck!"

ReplyQuote
Posted : April 11, 2020 6:45 am
SeaMonkey liked
SeaMonkey
(@seamonkey)
Eminent Member Registered Registered

Ha ha, fair play to you sir, fair play ?

ReplyQuote
Posted : April 11, 2020 10:18 am
safeshooter
(@safeshooter)
Trusted Member Moderator

The Bell Target has moved on, now with lighting 🙂
Things you do when you are bored

"it's a Fuster Cluck!"

ReplyQuote
Posted : April 17, 2020 5:46 pm
safeshooter
(@safeshooter)
Trusted Member Moderator

The internals: Simple desk bell and the striker is an old bit of metal attached to a small hinge. Works great 🙂

"it's a Fuster Cluck!"

ReplyQuote
Posted : April 18, 2020 2:01 pm